How to lay ceramic tiles the laying method of cera

2022-07-22
  • Detail

Ceramic tiles, also known as flower tiles or tiles, are usually matched with wall tiles or floor tiles. Porcelain chips have high requirements for the paving process. Because of its hollow structure, both sides of the porcelain chips do not contact the wall, so it is difficult to install. A large shape also requires several bricks to be spliced, which is weak in firmness. Then, how to lay the tiles? Don't worry, let's take a look at the laying method of porcelain tiles today

porcelain chips, also known as flower chips or tiles, usually each kind of porcelain chip will be matched with wall tiles or floor tiles. Porcelain chips have high requirements for the paving process. Because of its hollow structure, both sides of the porcelain chips do not contact the wall, so it is difficult to install. A large shape also requires several bricks to be spliced, which is weak in firmness. Then, how to lay the tiles? Don't worry, let's take a look at the laying method of porcelain tiles today

how to lay ceramic tiles the laying method of ceramic tiles

first of all, when pasting ceramic tiles, you should first clean the base course, ensure that there are no latex paint, lime paste and other decorations on the wall, and keep the ground clean. If the base course is not cleaned thoroughly, the cement mortar will not bond firmly with the base course. In addition, if there are cracks in the wall itself, please properly handle them before tiling, so as to avoid the cracking or falling off of porcelain chips in the future. Then the wall tiles should be fully soaked. Because the wall tiles have a relatively high moisture content, the base course should be fully watered and wetted before pasting. The tiles should also be soaked in water for about 20 minutes and fully dried in the shade before they can be used, otherwise it will affect the bonding fastness of the tiles

the floor tiles shall be paved with cement mortar first, and the floor tiles without cement shall be paved on the ground. After being flattened, the cement slurry shall be coated with the floor tiles and paved on the ground, and the diagonal positions of the four tiles shall be flush. The laying sequence is also exquisite. The floor tiles should be pasted from inside to outside. If there is a slope or floor drain on the ground, pay attention to slope making according to the drainage direction; The wall tiles should be paved from bottom to top. For the sake of beauty, the tiles at the bottom should be pasted later. Press the floor tiles after the wall tiles are pasted. In addition, one wall cannot be pasted to the top at one time, so as to prevent the porcelain chip from collapsing due to its heavy weight. Don't step on the floor tiles in a short time after paving

conclusion: there are many ways to lay tiles, which are worth discussing. Here is a brief introduction to how to lay and how to lay tiles. I hope it will be helpful to you. Please look forward to more information

郑州口腔医院

杭州妇科医院

徐州男科医院

济南血管瘤医院

Copyright © 2011 JIN SHI